Boosting ‘Megaflo’ and other unvented systems

A Shower Power Booster is the only pump sold which legally and safely boosts the hot water to and/or from an unvented hot water. It can also boost pressure to an unvented  tank, calorifier, or Megaflow. If the only problem is your hot water pressure then a SP2B can give a single boost, and a […]

Fitting a pump under a bath.

Fitting a pump under the bath is ideal if you only have a problem with just the bath taps or shower over the bath. Fitting pumps next to the hot water cylinder will improve all taps and showers but if the bathroom shower is the only problem, fitting a SP22S on the hot and cold […]

How To Install a pump in the Loft

The Shower Power Booster can be installed in the loft anywhere on the pipes up there (but not directly on the vent pipe -see diagram). Installing a pump in the loft above a hot water cylinder is a very good place for a Shower Power Booster Pump and after fitting the pump just raise the […]

WHOLE HOUSE SOLUTION (GRAVITY HOT AND MAINS COLD)

Fitting a Shower Power Booster near the hot water cylinder can boost every single tap or shower in a home. Top TipsStep One – Run the tap or shower you want to boost and check that the pipe you are intending to fit it on gets hot when the shower or tap you want to […]

How to fit a Shower Power Booster in the Loft – Gravity Hot and Mains Pressure Cold

The fitting of a Shower Power Booster in the loft is an easy DIY job. Top Tips To avoid the need for an electrician simply plug the transformer into a downstairs 3 pin plug and buy our 3 metre low voltage cable to get the power into the loft. Make sure that the pipe on […]